Warranty
Warranty for purchased goods
FoxSec® FS9020 is EN50131 Grade 2 compatible integrated security and access control system designed
for medium installations.
Securing 240 Areas, up to 240 zones (16 on main board, expandable to 240 zone inputs) and controlling
up to 31 access points.
FS9020 is designed for installations in commercial complexes and high-security installations.
FoxSec® FS9020 can communicate to building management systems via BACnet (optional) and can send events via IP Contact ID via Ethernet or Contact ID via telephone line.
All programming of FoxSec® FS9020 is done through FoxSecConf configuration software.
FoxSecConf is designed for use by installer (system programming).
- 16 zone inputs / 240 security areas
- 2 Wiegand - two doors (expandable up to 31 doors)
- Built-in Ethernet data communication
- Up to 2800 users in memory
- Up to 3500 access control logs + 2500 alarm logs in memory
- Power supply unit 16VAC up to 3,2A
- Battery control and capacity test
- Automation UDP port for integration with POS, etc.
- Up to 80 schedules
- Up to 48 keypad
- Up to 1000 relay outputs
- Up to 4 linked main panels
- Holidays
Metal enclosure protects components from Damage and tampering the device Mount to any wall surface, using three screws. The unit should be installed indoors, inside a secure area, such as in an IT or telecommunications room, utility closet, or on a wall above a suspended ceiling.
- RJ-45 connector for Ethernet TCP/IP
- Quick-disconnect screw terminal connectors:
- One RS-485 connection to other devices (optional, Assa Aperio)
- 16 on-board supervised inputs for security detectors
- 4 PGM outputs
- 2 transistor outputs for bell and strobe
- 4 non latching output relays for local alarm or other devices
- (rated 4 x 3A, 48VDC )
- 2 x card reader inputs (wiegand only)
- 1 x CANbus input for zone expander modules
- 1 x RS232 input for GSM modem
- 1 x R485 output for keypads
- AC/DC Power input
- Tamper inputs (enclosure door and wall)
- 24V output (optional). Only output modules and door modules
- The user should supply 12 VDC to connected interfaces. Separate supervised
- DC supplies with battery back-up are recommended for door locking or relay
- activated devices if consumption exceeds 2A
- 16-bit CPU Microcontroller, 80 MHz
- 512 k Flash memory inside microcontroller
- 256k EEPROM non-volatile memory
- 196k FRAM non-volatile memory
